Gujarat Technological University, Gujarat, Mechanical Engineering Semester 1, Engineering Graphics & Design Syllabus

Unit - 1 Introduction to Engineering Graphics

UNIT 1

Introduction to Engineering Graphics

1.1 Drawing instruments and accessories

1.2 BIS – SP 46

1.3 Use of plane scales

1.4 Diagonal Scales

1.5 Representative Fraction

Unit - 2 Loci of Points

UNIT 2

Loci of Points

2.1 Path of the points moving on Simple mechanisms

2.2 Slider crank mechanism

2.3 Four bar mechanism

Unit - 3 Engineering Curves

UNIT 3

Engineering Curves

3.1 Classification and application of Engineering Curves

3.2 Construction of Conics

3.1 Parabola

3.2 Hyperbola

3.3 Cycloidal Curves

3.4 Involutes and Spirals along with normal and tangent to each curve

3.3 Involute

Unit - 4 Projections of Points and Lines

UNIT 4

Projections of Points and Lines

4.1 Introduction to principal planes of projections

4.2 Projections of the points located in same quadrant and different quadrants

4.3 Projections of line with its inclination to one reference plane and with two reference planes

4.4 True length and inclination with the reference planes

Unit - 5 Projections of Planes

UNIT 5

Projections of Planes

5.1 Projections of planes polygons circle and ellipse with its inclination to one reference plane and with two reference planes

5.2 Concept of auxiliary plane method for projections of the plane

Unit - 6 Projections of Solids, Section of Solids and Development of Surfaces

UNIT 6

Projections of Solids Section of Solids and Development of

6.1 Classification of Solids

6.2 Projections of solids Cylinder Cone Pyramid and Prism

6.3 Section of such solids and the true shape of the section

6.4 Development of surfaces

Unit - 7 Orthographic Projections

UNIT 7

Orthographic Projections

7.1 Fundamental of projection along with classification

7.2 Projections from the pictorial view of the object on the 2 25 principal planes for view from front

7.3 top and sides using first angle projection method and third angle projection method

7.4 Full sectional view

Unit - 7 Orthographic Projections

UNIT 7

Orthographic Projections

7.1 Fundamental of projection along with classification

7.2 Projections from the pictorial view of the object on the 2 25 principal planes for view from front

7.3 top and sides using first angle projection method and third angle projection method

7.4 Full sectional view

Unit - 8 Isometric Projections and Isometric View or Drawing

UNIT 8

Isometric Projections and Isometric View or Drawing

8.1 Isometric Scale

Unit - 9 Computer Aided Drawing

UNIT 9

Computer Aided Drawing

9.1 Introduction to AutoCAD

9.2 Basic commands for 2D drawing